Honeywell HJZTP - SECTION 2: INSTALLATION; 2.1 CONNECTIONS

Rev. 1.01 3 900.0570
8-Sept-05
SECTION 2:
INSTALLATION
2.1 CONNECTIONS
All connections to and from the keyboard are made to the RJ type connectors located
on the rear panel of the unit.
Figure 1: HJZTP Rear Panel
Connector Function
KBD
(RS485)
Master keyboard – To connect to a slave keyboard.
Slave keyboard – To connect to a higher number slave keyboard.
VCL dome data input to master keyboard or last slave keyboard.
AUX
(RS485)
Master keyboard – To connect either to a DVR or a multiplexer.
slave keyboard – To connect either to the master keyboard, or a lower number
slave keyboard.
CONTROL
(RS485)
RS485 telemetry output – for connection to PTZs (Honeywell domes) or RS485
distribution box.
POWER Connection to 12VDC 300mA power supply (supplied).