Rev. 1.01 30 900.0570
8-Sept-05
HONEYWELL VCL PROTOCOL, CONTINUED
6.9.7 To Vary the Standard Speeds and Dwell Times of a Tour, Continued
The tour is now set up. To operate ‘Tour 3’:
Press ‘3’, then press the ‘autopan’ key.
Note: The range of the dwell times that can be set varies from 1 to 254 seconds.
Entering a time of ‘0’ will select 1 second dwell time.
6.9.8 To Stop a Tour of Presets
Press the ‘autopan’ key. (This will turn off the tour.)
The tour will also stop if the telemetry buttons or the joystick are used to control the
dome.
6.9.9 To Restart a Tour of Presets
Press the ‘autopan’ key. (This will start the last tour that the dome was carrying out.)
6.10 ENHANCED FUNCTIONS
The keyboard can also access most of the advanced functions of the RapidDome
/Orbiter series of domes by using its LCD menus. Joystick up, down, left and right or the
‘F1’ (‘▲’), ’F2’ (‘▼’), ‘F3’ (‘◄’) or ‘F4’ (‘►’) keys, are used to select options within the
menus. The ‘camera’ and ‘preset’ keys can also be used to move to the left or right
option.
The LCD menus adjust the setup of the dome that is currently being controlled (camera
number displayed on LCD display, before entering the menu).
Note: Menus are not accessible to users logged in as user level 2 (U2 displayed on the
LCD).
To enter the camera setup menu, press and hold ‘lock’, then press ‘F6’ (‘menu’). The
camera setup menu will be shown as below:
A U X = S E T L O C K = E N D
H O M E P R I V A C Y R E S E T
‘HOME’ will be flashing to indicate that ‘HOME’ is the currently selected option.
Use joystick down or ’F2’ (‘▼’), to select the other options as shown below:
A U X = S E T L O C K = E N D
Z O O M I R / L A M P A U T O 1 8 0
Use joystick up or ‘F1’ (‘▲’), to return to the ‘HOME’, ‘PRIVACY’, ‘RESET’ options.
To Next Page
Loading...
