Ë-»® ײ-¬®«½¬ ·±²- ó Û²¹´·-¸
12
Fig. 1
5.2 Installation of MightEvac
(Ref. Fig. 1)
Step 1: Remove red, round protective stickers from both sides of the MightEvac unit.
Step 2: Insert attachment swivel of the unit into bracket as shown.
Step 3: Slide the unit forward until the threaded holes in the housing (where stickers were removed)
are aligned with the holes in the front of the bracket as shown.
NOTE: The carrying handle of the unit must be in the upward position away from the bracket.
Insert the fastener through the
lockwasher, spacer and hole in the
bracket. Tighten to 8 plus or minus
one (1) ft.-lbs. (96 plus or minus 12
in.-lbs.). Repeat for opposite side.
Step 4: Insert the pushpin through the
bracket in the holes provided. This
securely attaches the unit to the
bracket. Ensure the pushpin is
securely through both holes and
remains in place.
Step 5: Attach the unit with bracket to an
approved Miller anchoring device
and secure with the pushpins
provided. Refer to installation
procedures in sections 5.3, 5.4, 5.5, 5.6 and 5.7 of this manual.
To remove the unit, simply reverse the above procedures.
5.0 Installation
For general fall protection, connect the lifeline
end connector (i.e., snap hook) to the back
D-ring on the full-body harness.
The MightEvac Self-Retracting Lifeline must be
mounted to an overhead anchorage by the attachment
swivel using a locking carabiner or other Miller approved
anchorage connector, or it must be used in conjunction
with a Miller mounting bracket which is then installed on
a tripod. The anchorage must be capable of supporting
a 5,000 lb. (22.2kN) tensile load. Review all warnings
and instructions when selecting a mounting location.
ANCHORAGE
CONNECTOR
LOCKING
CARABINER
ANCHORAGE
MAY RESULT IN SERIOUS OR FATALINJURY
WARNING! FAILURE TO OBSERVE INSTRUCTIONS
PAT. NO. 5,771,993
SELF-RET RAC TING LIFELI NE WI TH EME RGE NCY RE SCUE
®
• Always use and inspect unit in accordance
with manufacturer’s instructions.
• Do not use as a restraint or positioning
device.
• Use only with attachment fittings and safety
harness recommended by manufacture r.
• Always connect the hook directly to
attachment point on harness.
• Guard against swing falls by keeping the
lifeline vertically overhead. Never work
above the device.
• Keep user and other workers from becoming
entangled in lifeline.
• Do not allow lifeline to drag over
obstructions.
• Never clamp off or stand on the lifeline.
• Do not allow the lifeline to become slack.
• Do not allow cable, rope or webbing
lifelines to come in contact with anythin g
that will damage the lifeline including, but
not limited to, sharp, abrasive, rough or
high-temperature surfaces, welding, he at
sources, electrical hazards, or moving
machinery.
• Wear gloves when inspecting or handling
cable lifelines.
• Check lifeline for damage, frays, or cuts that
will reduce the strength.
• Maintain tension on the lifeline while letting
it retract after disconnecting from wo rker.
• Servicing must only be performed by the
manufacturer or an approved agent.
WARNI NG: Ma nufacturer ’s instru ctions supplied with t his pro duct at t ime of shipme nt must be foll owed: Failure t o do so could resul t in seriou s
injury o r death. Only for use by ONE person as a pers onal fall arrester. Device m ust b e taken out of servic e for ins pectio n and recertif ication
after arres ting a fa ll or when the imp act indicat or h as been ac tivated. Contact Miller Fall Protec tion if in struc tion manu al is ne eded.
ADVE RTENC IA: Deb en seguir se los instrucc iones del fabri cate pro vistas co n este producto al mome nto de d espach o: El no ha cerio
pued e resu ltar en les iones gr aves o la muert e. Sol o par a el uso po r UNA S OLA per sona co ma de tentor pe rsonal c ontra c aidas. El
dispos itivo d ebe retir arse d el servi cio pa ra ser in specc ionado y recer tificati on lue go de hab er deten ido una caida o cuand o se ha ya
activa do el indi cator de im pacto. Si se req uiere el manual d e instruc ciones consu lte con M iller Fa ll Prote ction.
ADVE RTISSEM EN T: Vou s devez respecter les i nstruct ions d u fabrican t que vo us avez recues avec le produit : Dans le cas
contrai re, vou s risque z de bles sures graves ou meme lamort. Utiliser seule ment pa r UNE pe rsonne co mme arr et de chute
person nelle. L’appareil doit etre mi s hors d ’utilisation p our insp ection et rec ertificati on apres avoir arrete un e chut e ou
lorsq ue l’indicateu r d’imp act a et e active. Co ntactez Miller F all Prot ection si vous av ez besoi n d’un nouvea u man uel.
LB388
Rev. D
MFP9350111
ATTACHMENT
SWIVEL
MIGHTEVAC
WITH MOUNTING BRACKET
To Next Page
Loading...
