Ë-»® ײ-¬®«½¬ ·±²- ó Û²¹´·-¸
15
Add 3 ft (.9m) of fall clearance
to calculation if user may
be working in a crouched or
kneeling position.
Add 5 ft. (1.5m) of fall clear-
ance if user may be working
in a lying down position.
Worker must not be exposed
to a swing fall hazard.
If there is any question
about calculating fall clearance distance,
please contact Honeywell Technical Services:
1-800-873-5242 (press 4) /
02.48.52.40.40
Whenever a worker may not be working
directly under the anchor point or may be
moving back and forth from the vertical of
the unit, the swing fall factor must be in-
cluded in the fall clearance calculation. Fall
clearance distance will increase according
Honeywell Technical Services can help you
calculate the added fall clearance required...
call 1-800-873-5242 (press 4).
Fig. 8b
Fig. 8c
Fig. 8d
7.0 Training
The purchaser of this equipment must ensure that all personnel using this equipment are familiar
with these instructions and are properly trained in the operation, limitations, installation, inspec-
tion and maintenance of this product. Training should be conducted periodically and without
exposing the trainee to a fall hazard.
NOTE: Excessive training on this device will cause the gears in the unit to wear, thus reducing
its life expectancy and will consequently require more frequent servicing. The retrieval mecha-
nism in this device is for emergency use only. Do not use for routine hoisting of personnel or
materials.
Miller Training can provide the knowledge and skills necessary to achieve a safe, more productive
work environment. For more information, contact a representative today at 800-873-5242 /
02.48.52.40.40.
To Next Page
Loading...
Need help?
General
