Honeywell NOTIFIER UDACT - Page 6

Table of Contents
6 UDACT Instruction Manual — P/N 50050:M 12/18/2009
3.4.8: Secondary Number 24-Hour Test Time (47-50) ..............................................................................32
3.4.9: Secondary Number 24/12 Hour Test Time (51)................................................................................32
3.4.10: Start Monitoring Address (52-53) ...................................................................................................32
3.4.11: End Monitoring Address (54-55).....................................................................................................32
3.4.12: UDACT Communication Selection (56) .........................................................................................33
3.4.13: Backup Reporting (57) ....................................................................................................................34
3.4.14: Touchtone/Rotary Select (58)..........................................................................................................34
3.4.15: Make Break Ratio (59) ....................................................................................................................34
3.4.16: Address (60).....................................................................................................................................34
3.4.17: Address (61).....................................................................................................................................34
3.4.18: AC Loss Reporting Delay (62)........................................................................................................34
3.4.19: Host Panel ID (63)...........................................................................................................................34
3.4.20: Loop Number (64 - 65)....................................................................................................................35
3.4.21: Device/Zone Number (66 - 68)........................................................................................................35
3.4.22: Programming Event Codes (69-208)...............................................................................................35
3.4.23: Programming the Real-Time Clock.................................................................................................36
3.4.24: End Programming............................................................................................................................36
3.5: 3+1, 4+1 Express and 4+1 Standard Formats..............................................................................................37
3.5.1: Primary Number ................................................................................................................................37
3.5.2: Secondary Number ............................................................................................................................38
3.6: 4+2 Standard and 4+2 Express Formats ......................................................................................................39
3.6.1: Primary Number ................................................................................................................................39
3.6.2: Secondary Number ............................................................................................................................40
3.7: Ademco Contact ID Format.........................................................................................................................41
3.7.1: Primary Number ................................................................................................................................41
3.7.2: Secondary Number ............................................................................................................................42
3.8: Programming Reference Sheets...................................................................................................................43
3.8.1: Options...............................................................................................................................................43
3.8.2: Event Codes.......................................................................................................................................45
3.9: Factory Default Settings ..............................................................................................................................46
Section 4: Operating Instructions.........................................................................................48
4.1: Normal Mode...............................................................................................................................................48
4.1.1: Function Keys....................................................................................................................................48
4.1.2: Displays and LEDs ............................................................................................................................49
4.1.3: Normal Mode Operation....................................................................................................................50
4.1.4: Key Report Descriptions....................................................................................................................52
4.2: Type Mode ...................................................................................................................................................52
4.2.1: Disabling of Zones or Points .............................................................................................................54
4.2.2: Zone or Point Supervisory.................................................................................................................54
4.3: Troubleshoot Mode......................................................................................................................................54
4.3.1: Telephone Line Testing.....................................................................................................................54
4.4: Lamp Test Mode ..........................................................................................................................................55
Section 5: Reporting Formats ...............................................................................................56
5.1: Data Reporting Structure .............................................................................................................................56
5.1.1: Ademco Contact ID...........................................................................................................................58
Section 6: Compatible Receivers..........................................................................................61
6.1: UL Listed Receivers ....................................................................................................................................61
Appendix A: AFP-100 (UL 8th)...............................................................................................63
A.1: General........................................................................................................................................................63
A.2: Mounting.....................................................................................................................................................63
A.2.1: Internal..............................................................................................................................................63
A.2.2: Remote..............................................................................................................................................64
A.3: Wiring..........................................................................................................................................................64
A.3.1: Connections ......................................................................................................................................64