Honeywell PC42d - Testing

L3-GLBL-RPR-4260 (Rev A)
It is a requirement to run the printer through the service test especially when replacing new main logic board (MLB), peripheral
PCBA, and removing the top cover.
Testing Instructions
1. See PC42d Printers Final Test Procedure OTPPC42d-000 for test procedure and setup.
2. The PC42d Printers Final Test Software (405-xxx-xxx) can be found on the Intermec Service Repair Information (SRI)
site at:
http://in/depts/service/Main/ServiceQualityTestEngineering/ServiceQualityTestEngineering/Service%20Repair%20Information%20S
RI/default.aspx. Access to this site is available to Intermec Team Members only.
3. The test fixture bill of material for PC42d Printers Final Test (405-xxx-xxx) can be found on Intermec Service Repair
Information (SRI) site at:
http://in/depts/service/Main/ServiceQualityTestEngineering/ServiceQualityTestEngineering/Service%20Repair%20Information%20S
RI/default.aspx. Access to this site is available to Intermec Team Members only.
Honeywell Scanning & Mobility
9680 Old Bailes Road
Fort Mill, SC 29707
www.honeywellaidc.com
OPERATION:
Testing
TITLE
Model
DOCUMENT NO.
PAGE
PC42d Service Repair Manual PC42d
L3-GLBL-RPR-4260
(Rev A)
Page 25 of 25