Appendix B — Default Settings
48 PC42t Desktop Printer User Guide
Default Configuration
Use this appendix to view the default settings on the printer. If you
restore the printer to factory default settings, it will use the values listed
here. The order of the settings reflects the organization of the printer
web page.
Serial Port Settings
This section describes the serial port settings. To view these settings:
• From the printer web page, click the Configure tab >
Communications > Serial.
Note: These settings are not accessible unless you have the optional
serial port installed and a connection to a PC.
Serial Port Settings
Setting Description Default
Baud Rate Transmission speed in bits per second (bps) for the
serial port.
115200
Data Bits Number of bits that define a character or byte. 8
Parity Specifies how the printer checks the integrity of the
transmitted data.
None
Stop Bits Number of bits sent at the end of every character to
allow the receiving signal hardware to detect the end
of a character and to resynchronize with the character
stream.
1
Hardware Specifies if hardware flow control (RTS/CTS) is used
to manage the rate of data transmission between the
device and the host.
Disable
ENQ/ACK Specifies if software flow control (ENQ/ACK) is used
to manage the rate of data transmission between the
device and the host.
Disable
XON/XOFF To Specifies if software flow control (XON/XOFF) is used
to manage the rate of data transmission to the host.
Disable
XON/XOFF From Specifies if software flow control (XON/XOFF) is used
to manage the rate of data transmission from the
host.
Disable