Honeywell PD45 User Manual

x
Safety Warnings
Caution Statements
Shipping the Printer
To avoid printer damage during transit:
1. Power off the printer and remove all cables.
2. Remove media and ribbon (if installed) from the printer.
3. Lower the printhead and front arm.
4. Pack the printer in the original container.
Note: Honeywell is not responsible for any damage caused during shipment/transit.
Warning: Do not put your fingers inside the print mechanism when the
power is on.
Warning: This printer contains a coin battery and is NOT user
replaceable. Keep children away from the printer when the
printer is in service.
Never put batteries in your mouth as swallowing may lead to
serious injury or death. If swallowed, seek medical attention
immediately from a physician or local poison control center.
Caution: Observe all safety and accident prevention regulations
applicable to your specific region and application.
Caution: You must implement both hardware and software safety
precautions to prevent the possibility of undefined system
states.
Caution: You must make sure that dangerous conditions cannot occur
under any circumstances, even for a brief period of time.
Caution: To reduce the risk of electric shock or fire, keep the cover closed
and turn off the printer when not in use. There are no user-
serviceable parts inside the power supply unit.

Honeywell PD45 Specifications

General

Print Technology	Direct Thermal / Thermal Transfer
Ribbon Core	1 inch (25.4 mm)
Print Resolution	203 dpi
Max Print Width	4.25 inches (108 mm)
Max Print Speed	8 ips (203 mm/s)
Connectivity	USB 2.0, RS-232, Ethernet
Media Handling	Label gap, label black mark
Media Thickness	0.0025 inch to 0.01 inch (0.0635 mm to 0.254 mm)
Ribbon Width	1 inch to 4.33 inches (25.4 mm to 110 mm)
Ribbon Length	984 feet (300 meters)
Operating Temperature	5°C to 40°C (41°F to 104°F)
Power Requirements	100-240 VAC, 50/60 Hz
Media Width	25.4 mm (1 in) to 118 mm (4.65 in)