Honeywell Performance HRG4 - Figure 2-10 Entering the Network Settings Window; Figure 2-11 Network Settings Window; Figure 2-12 Setting the Date and Time

800-12005V1 - A - 08/2012
Getting Started | 41
Figure 2-10 Entering the Network Settings Window
15. At the prompt, click Enter to open the Network Settings window (see Figure 2-11).
Figure 2-11 Network Settings Window
16. Enter the IP Address, Subnet Mask, and Default Gateway.
17. Click OK to return to the Setup Wizard.
18. When you are finished entering settings, click Done to close the Setup Wizard.
This completes the initial setup process. Continue to Setting the Date and Time.