800-12005V1 - A - 08/2012
Alarm Settings | 81
Figure 7-22 Exception Menu
Understanding Exception Trigger Options
When setting up exception handles for such features as motion detection and relay alarms, you
can select triggering options to alert you of these exceptions.
The triggering options include:
• Pop-up Image on Monitor: When an alarm is triggered, the local monitor (VGA or BNC
monitor) will display an image in Live View mode. This alarm can be configured under the
Popup Alarm Image handle method. For alarms that are triggered simultaneously, images
will be displayed one at a time every 10 seconds (default dwell time). A different dwell time
can be set by going to Menu
Settings Display Dwell Time. Once the alarm
stops, cycling of the images will also stop and you will be returned to the Live View screen.
• Audio Warning: Trigger an audible beep when exception is detected.
• Notify Surveillance Centre: Sends a signal to remote alarm host when exception is
detected (see Configuring Remote Alarm Host Settings on page 77).
• Trigger Alarm Output: Trigger an alarm output when an exception is detected. Alarm
output can be configured by following the steps listed in Sensor Alarm Settings.
To Next Page
Loading...
Need help?
General