User’s Guide SMX-AUS
NS-MN-0032 / 11.2020 13
5.3 Fire Fan Control Panel (FFCP) - User Control Keys - Function Descriptions
Keys Descriptions
ON Press to activate the Fire Fan in manual mode.
AUTO Press to operate the Fire Fan in Auto mode. The Fire Fan operation shall be initiated by the alarm condition in the panel.
OFF Press to stop the Fire Fan in manual mode.
FIRE MODE RESET Press to reset the FFCP from fire mode. Also, resets the relay outputs configured for Fire Trip latching.
5.4 Fire Fan Control Panel (FFCP) LED Indications
The following table provides the details of the LED indications on the FFCP:
Indicator Color Function To Clear the Indication
RUN Red This
illuminates steadily to indicate that the Fire Fan is
running.
This LED flashes to indicate that a detector from a duct
detector zone has sensed smoke.
Correct the condition causing the alarm and then perform Silence Alarm
followed by panel reset and Fire Mode Reset.
FAULT Yellow
This indicates that the Fire Fan is in fault condition
, caused
by either a fault input from the fan, or a mismatch in the fan
status or a fault in the input/output control modules of the
fan.
Correct the condition causing the fault.
STOP Green This indicates that the Fire Fan is stopped. Not Applicable
ON Red This indicates that the Fire Fan is running in manual mode.
Not Applicable
AUTO Red This indicates that the Fire Fan is in Auto mode. Not Applicable
OFF Red This indicates that the Fire Fan is stopped in manual mode.
Not Applicable
FIRE MODE RESET Red This indicates that the FFCP is in fire mode. Correct the condition causing the alarm and then perform Silence Alarm
followed by panel reset and Fire Mode Reset.
To Next Page
Loading...
