User’s Guide SMX-AUS
NS-MN-0032 / 11.2020 9
2 Introduction
Fig. 1: Fire alarm control panel SMX-AUS
The fire alarm control panel SMX-AUS is available with:
• Metal enclosure with glass door and MCP
• 1 loop and 2 loops (CLIP protocol)
• 5-inch touch screen
• LED indicators to know the status of power, system etc.
• Supports max. 160 zones (system-wide)
2.1 Features
Following are some of the features of the fire alarm control panel:
Connections to one or two Signalling Line
Circuit (SLC) loops (CLIP protocol)
• Onboard alarm, fault, and programmable relays
• Multi-colour touch screen display
• RS485 connections for wiring annunciators
• RS232 connection for printer
• Firmware upgrade or downgrade through USB
• Portable configuration settings (through USB or
Bluetooth)
• Backing up the event logs (through USB or
Bluetooth)
• Multi-level access control (Level 1, 2, 3, and 4)
• All sounder deactivation via programming
• Auto-learning capability
• Configuration options: USB storage device,
mobile app, and the panel interface
10,000 event logs for SMX-AUS
• View pulse width (PW) values
• View voltage and analogue values
• Onboard monitored input for supervisory
• Set date and time
• Walk test - with all sounders / one selective
sounder/ without any sounder options
• Point, Zone, Logic Zone, Output Group and
programmable Relay Disablements
• Alarm Delay Facility (ADF) and Alarm
Verification Facility (AVF)
• Up to 4 Fire Fan Control groups using SLC loop
modules, along with duct detector support and
Fire Fan Control Panel (FFCP) on fascia
• Occupant Warning System (OWS) support
160 programmable zones (system-wide)
• Door MCP for fire alarm
• Add-on Relay I/O Card with Alarm Routing
Equipment interface and one programmable
Relay
• 100 logic zones with AND, OR, NOT logic
conditions
• Non-latched supervisory action for detectors
and modules
• Configurable alarm sensitivity levels for smoke
and multi sensors
• Fire-Trip latching for relays and control
modules, until Fire Mode Reset
• Integration to external systems using printer
port
To Next Page
Loading...
