Honeywell SMX-AUS - ENABLE OR DISABLE - LOGIC ZONE

User’s Guide SMX-AUS
28 NS-MN-0032 / 11.2020
7.2.3 ENABLE OR DISABLE – LOGIC ZONE
Perform the following steps to enable or disable Logic Zones:
1.
In ENABLE/DISABLE tab, tap LOGIC ZONES to enable or disable a logic zone.
The Logic Zones screen opens with a list of programmed logic zones in the panel.
2.
Tap DETAILS to view operators applied, inputs and outputs associated with the logic zone.
3.
Tap ENABLE to enable a logic zone or tap DISABLE to disable a logic zone.
Fig. 26: Logic Zone Enable or Disable
•
When a logic zone is disabled, all its associated outputs get inhibited from activation.
• In case, the output(s) are already activated by the logic zone, performing the logic zone disablement will deactivate all its associated output(s).
• A logic zone which is disabled, is evaluated as logic 0, if it is part of/ cascaded as an input to other logic zones.
• After the logic zone is re-enabled, all its associated output(s) return to the required state, as per the configured logic rule.