31-00400M-01 | Rev10-20 29
STEP 3. CONFIGURATION THROUGH THERMOSTAT TOUCHSCREEN DISPLAY
Setting up the Conventional or Heat Pump equipments
Setting up conventional type of equipment
1. Tap Conventional.
Figure 12 Select Conventional type of equipment
2. Select the number of Cooling stages.
Tap corresponding number to select number of stages.
Figure 13 Select number of colling stages
3. Tap NEXT
User will be prompted to select the Heating Type/Stages
4. Tap corresponding number to select number of stages.
To set up modulating heating type, tap on Modulating toggle.
To Next Page
Loading...
Need help?
General
