Honeywell Vocollect Talkman A700 - Page 51

SolutionError Message
"Noise sampling procedure timed out."
1.
Sample noise again.
2.
Reboot the device.
"Operator load failed."
1.
Go to an area of known good coverage.
2.
Turn the device off and then turn it back on again.
3.
Reboot the device.
4.
Reload VoiceClient.
"Power-off error."
1.
Power on the device.
2.
Reboot the device.
Edit the task configuration file, taskname.vcf, and change the
line selftest=1 to selftest=0.
"Self test mode set, but no script file
found."
"Software error while changing task. Task
unchanged."
1.
Go to an area of known good coverage.
2.
Turn the device off and then turn it back on again.
3.
Reload the task.
4.
Reboot the device.
5.
Reload VoiceClient.
"Task load failed."
1.
Go to an area of known good coverage.
2.
Turn the device off and then turn it back on again.
3.
Reload the task.
4.
Reboot the device.
5.
Reload VoiceClient.
"Task not loaded. No task name available."
1.
Reload the task.
2.
Turn the device off and then turn it back on again.
3.
Reboot the device.
4.
Reload VoiceClient.
"Telnet client process failed to start."
1.
Turn the device off and then turn it back on again.
2.
Reboot the device.
3.
Reload VoiceClient.
"Telnet session manager failed to start."
1.
Turn the device off and then turn it back on again.
2.
Reboot the device.
3.
Reload VoiceClient.
"Telnet VT220 emulation process failed to
start."
1.
Turn the device off and then turn it back on again.
2.
Reboot the device.
3.
Reload VoiceClient.
"Unable to receive input data."
1.
Turn the device off and then turn it back on again.
Confidential: For informational use by Honeywell resellers and customers only
Troubleshooting Equipment Problems | 51