Honeywell Vocollect Talkman A700 - Page 50

SolutionError Message
4.
Reload VoiceClient.
"Firmware error while changing task. Task
not changed."
1.
Reload the task.
2.
Turn the device off and then turn it back on again.
3.
Reboot the device.
4.
Reload VoiceClient.
"Flash error."
1.
Turn the device off and then turn it back on again.
2.
Reboot the device.
3.
Reload VoiceClient.
"Flash is full. Please wait while Talkman
turns off."
1.
Go to an area of known good coverage.
2.
Turn the device off and then turn it back on again.
3.
Reboot the device.
4.
Reload VoiceClient.
Change the battery."Headset battery is getting low."
Change the battery."Headset battery is getting low. Change
headset battery now."
"Initializing operator failed. Please reload
operator."
1.
Reload the operator.
2.
Turn the device off and then turn it back on again.
3.
Reboot the device.
4.
Reload VoiceClient.
"Internal error loading operator."
1.
Turn the device off and then turn it back on again.
2.
Reboot the device.
3.
Reload VoiceClient.
Select the operator again or load a different operator."Invalid operator file name."
"Invalid device Manager Host name or
address."
"Invalid device Manager Service name or
port."
"No task list file found. Task unchanged."
1.
Reload the task.
2.
Turn the device off and then turn it back on again.
3.
Reboot the device.
4.
Reload VoiceClient.
"Noise sampling procedure failed."
1.
Sample noise again.
2.
Go to a quieter location and perform another noise sample.
3.
Try using another headset and perform the noise sample.
Note: If this solves the problem, the first headset might be
damaged.
Confidential: For informational use by Honeywell resellers and customers only
50 | Vocollect Talkman A700 Product Guide