292 Xenon XP User Guide
About Disinfectant-ready Models
Some configurations of Xenon XP scanners are available with an external plastic
housing that is designed to resist the effects of harsh chemicals. These scanners
are equipped with disinfectant-ready housings (DRH) for the healthcare and
general-purpose markets.
Please refer to the Honeywell Safety and Productivity Solutions website for specific
details on how to clean Xenon XP scanners with disinfectant-ready housings.
Helpful information on the care of these specialty products can be found in the
following articles:
• Learn to Clean Honeywell Healthcare Disinfectant-ready Products
• Honeywell Instructions for Cleaning General Purpose Disinfectant-ready
Housing Devices
• Disinfectant-Ready Application Brief
Inspect Cords and Connectors
Inspect the interface cable and connector for wear or other signs of damage. A
badly worn cable or damaged connector may interfere with scanner operation.
Contact your distributor for information about cable replacement. Cable
replacement instructions are on page 292.
Replace Cables in Corded Scanners
The standard interface cable is attached to the scanner with an 10-pin modular
connector. When properly seated, the connector is held in the scanner’s handle by
a flexible retention tab. The interface cable is designed to be field replaceable.
• Order replacement cables from Honeywell or from an authorized distributor.
• When ordering a replacement cable, specify the cable part number of the
original interface cable.
To Next Page
Loading...
