18
The signals for both end positions are transmitted
from the motor to the computer. The signal for
middle position is switched by the sensor on the
metering unit.
Continue to next page
Half width shut off
After selecting the half width shut
o in the machine conguration, the
two symbols for left and right hand
on the second work page.
As soon as a key for shutting down a half width
is pressed, the corresponding half width will ash
in the displayed graph, until the sensor sends
a signal to the computer when end position is
reached.
In end position the closed half width is hidden.
The seed quantity is reduced by half, the seed
quantity display in kg/ha remains unchanged,
because the working width has also been
halved.
After pressing the same key again the total
working width is available again and the display
shows the complete machine.
To Next Page
Loading...