horsch DrillManager - Input of Machine Data

30
7. In case of a missing speed signal (e.g. radar
defective) an emergency program can be
switched on and sowing can be continued
with the simulation speed. The radar should
in this case be unplugged. The simulation
speed can be changed here. The metering
motor in this case runs with the same speed
as the speed speci󰘰ed.
8. Metering unit ON / OFF; A metering unit can
be quickly switched o󰘯 and on again with
these keys. A switched o󰘯 metering unit is
displayed expunged.
Back to the drill program:
First "work page".
Input of machine data
The machine data must be entered
before initial start-up of the machine.
After switching on, the 󰘰rst page of the main
menu is displayed. Use the arrow key to switch
to the second page. The key for machine data
opens a further selection page.
1. Metering quantity adjustment with the + and
- % keys. The adjustment value cannot be
adjusted here.
2. Coulter pressure Step; on machines with
hydraulic coulter pressure adjustment and
extension for automatic control one can
choose here whether the seed quantity
should be adjusted together with the coulter
pressure adjustment. The seed quantity is
increased by a value set in the Delta Step
(1), when resetting the quantity adjustment
is also reset.
3. Speci󰘰cation of metering quantity in kg/ha
for metering unit I.
4. Switch the adjustment of metering
quantity "On" or "O󰘯" with the + and - % keys.
5. Speci󰘰cation of quantity for metering unit II.
Fertiliser in kg/ha or liquid fertiliser in l/ha.
6. Selection of whether the quantity of solid or
liquid fertiliser is to be adjusted with the +
or - % keys.
5
4
6
1
3
7
2
8