HP 5120 series User Manual

42
To do… Use the command… Remarks
Enable command accounting command accounting
Optional
• By default, command
accounting is disabled. The
accounting server does not
record the commands executed
by users.
• Command accounting allows
the HWTACACS server to
record all executed commands
that are supported by the
device, regardless of the
command execution result. This
helps control and monitor user
operations on the device. If
command accounting is
enabled and command
authorization is not enabled,
every executed command is
recorded on the HWTACACS
server. If both command
accounting and command
authorization are enabled, only
the authorized and executed
commands are recorded on the
HWTACACS server.
• Configure the AAA accounting
server before enabling
command accounting.
Exit to system view quit —
Configure
the
authentic
ation
mode
Enter the default ISP
domain view
domain domain-name
Optional
By default, the AAA scheme is
local.
If you specify the local AAA
scheme, perform the configuration
concerning local user as well. If you
specify an existing scheme by
providing the radius-scheme-name
argument, perform the following
configuration as well:
• For RADIUS and HWTACACS
configuration, see the Security
Configuration Guide.
• Configure the username and
password on the AAA server.
(For more information, see the
Security Configuration Guide.)
Specify the AAA
scheme to be applied to
the domain
authentication default
{ hwtacacs-scheme
hwtacacs-scheme-name [ local ]
| local | none | radius-scheme
radius-scheme-name [ local ] }
Exit to system view quit
Create a local user and enter local
user view
local-user user-name By default, no local user exists.
Set the local password
password { cipher | simple }
password
Required
By default, no local password is set.

HP 5120 series Specifications

General

Brand	HP
Model	5120 series
Category	Switch
Language	English