138
Figure 45 Port group configuration
# Select Service Parameters > Validate System Configuration from the navigation tree to validate the
configurations.
2. Configure the portal server (iMC PLAT 5.0)
NOTE:
This example assumes that the portal server runs on iMC PLAT 5.0(E0101) and iMC UAM 5.0(E0101).
# Configure the portal server.
Log in to the iMC management platform and select the Service tab. Then, select User Access Manager >
Portal Service Management > Server from the navigation tree to enter the portal server configuration
page, as shown in Figure 51.
• C
onfigure the portal server parameters as needed. This example uses the default settings.
To Next Page
Loading...
