151
Figure 58 Device list
On the port group configuration page, click Add to enter the page shown in Figure 64. Perform the
following configurations:
• Enter the port group name.
• Select the configured IP address group. The IP address used by the user to access the network must
be within this IP address group.
• Use the default settings for other parameters.
Figure 59 Add a port group
# Select Service Parameters > Validate System Configuration from the navigation tree to validate the
configurations.
2. Configure the portal server (iMC PLAT 5.0)
NOTE:
This example assumes that the portal server runs on iMC PLAT 5.0(E0101) and iMC UAM 5.0(E0101).
# Configure the portal server.
Log in to the iMC management platform and select the Service tab. Then, select User Access Manager >
Portal Service Management > Server from the navigation tree to enter the portal server configuration
page, as shown in Figure 65.
• C
onfigure the portal server heartbeat interval and user heartbeat interval.
• Use default values for other parameters.
To Next Page
Loading...
