275
[Switch-ui-vty0-15] quit
# Configure a local user named client002 with the password being aabbcc and the service type being
SSH.
[Switch] local-user client002
[Switch-luser-client002] password simple aabbcc
[Switch-luser-client002] service-type ssh
[Switch-luser-client002] quit
# Configure the user authentication method as password and service type as SFTP.
[Switch] ssh user client002 service-type sftp authentication-type password
2. Establish a connection between the SFTP client and the SFTP server
NOTE:
• The device support many types of SFTP client software. The following takes the PSFTP of PuTTy Version
0.58 as an example.
• The PSFTP supports only password authentication.
# Establish a connection to the remote SFTP server.
Run the psftp.exe to launch the client interface as shown in Figure 98,
and enter the following command:
open 192.168.1.45
Enter username client002 and password aabbcc as prompted to log in to the SFTP server.
Figure 93 SFTP client interface
To Next Page
Loading...
