2. Loosen the knobs on the two substrate anges. The following illustration shows a loosened ange (1) and
a tightened ange (2).
3. Insert a loosened ange into one end of the substrate roll and tighten the knob. Verify that the ange is
secure. Then do the same at the other side of the roll.
4. Place the ange-equipped roll on the substrate supply rollers. Set the anges inside the groove of the
ange guide. The ange guides can be moved laterally on the roller.
If the anges are not used (this is not recommended, because then tracking is not guaranteed), then make
sure that the roll is situated between the two ange guides.
5. Start feeding the substrate in from the rear of the machine. Pass the substrate underneath the pinch rollers
towards the front of the cutter.
6. Position the left substrate edge on the leftmost drive sleeve and check that the right substrate edge is
positioned over the long drive sleeve.
NOTE: If you have the HP 54 Basic Cutter, load the substrate as shown in the table below.
ENWW 13
To Next Page
Loading...
