174
• Enter the start IP address and end IP address of the IP group. Make sure that the host IP address is
in the IP group.
• Select a service group. By default, the group Ungrouped is used.
• Select the IP group type Normal.
Figure 64 Adding an IP address group
# Add a portal device.
Select User Access Manager > Portal Service Management > Device from the navigation tree to enter the
portal device configuration page. Then, click Add to enter the page shown in Figure 48.
• En
ter the device name NAS.
• Enter the IP address of the switch's interface connected to the user.
• Enter the key, which must be the same as that configured on the switch.
• Set whether to enable IP address reallocation. This example uses direct portal authentication, and
therefore select No from the Reallocate IP list.
• Set whether to support the portal server heartbeat and user heartbeat functions. In this example,
select Yes for both Support Server Heartbeat and Support User Heartbeat.
Figure 65 Adding a portal device
To Next Page
Loading...
