HP 6125XLG - PIM Configuration Examples; PIM-DM Configuration Example

117
Task Command
Display PIM routing table
information.
display pim [ vpn-instance vpn-instance-name ] routing-table
[ group-address [ mask { mask-length | mask } ] | source-address [ mask
{ mask-length | mask } ] | flags flag-value | fsm | incoming-interface
interface-type interface-number | mode mode-type | outgoing-interface
{ exclude | include | match } interface-type interface-number ] *
Display RP information in the
PIM-SM domain.
display pim [ vpn-instance vpn-instance-name ] rp-info [ group-address ]
Display statistics for PIM packets. display pim statistics
PIM configuration examples
PIM-DM configuration example
Network requirements
As shown in Figure 45:
• VOD streams are sent to receiver hosts in multicast. The receiver groups of different organizations
form stub networks, and one or more receiver hosts exist in each stub network. The entire PIM
domain operates in the dense mode.
• Host A and Host C are multicast receivers in two stub networks.
• IGMPv2 runs between Switch A and N1 and between Switch B, Switch C, and N2.
Figure 45 Network diagram
Source
10.110.5.100/24
PIM-DM
Switch A
Switch B
Switch C
Switch D
Receiver
Host A
Host B
Host C
Host D
Receiver
Vlan-int100
Vlan-int200
Vlan-int200
Vlan-int300 Vlan-int101
Vlan-int101
Vlan-
i
nt1
02
Vlan-
i
nt1
02
Vl
an-in
t1
03
Vlan-int1
0
3