HP 6125XLG - Configuring Ipv6 BIDIR-PIM; Configuring Switchover to SPT; Ipv6 BIDIR-PIM Configuration Task List

297
• The ACL does not define a deny or permit action for a matching register message.
In view of information integrity of a register message in the transmission process, you can configure the
device to calculate the checksum based on the entire register message. If a device that does not support
this function is present on the network, you can configure the device to calculate the checksum based on
the register message header.
To configure IPv6 multicast source registration:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter IPv6 PIM view.
ipv6 pim [ vpn-instance
vpn-instance-name ]
N/A
3. Configure a filtering rule for
register messages.
register-policy acl6-number
By default, no register filtering rule
exists.
4. Configure the device to
calculate the checksum based
on the entire register
message.
register-whole-checksum
By default, the device calculates
the checksum based on the header
of a register message.
Configuring switchover to SPT
CAUTION:
If the router is an RP, disabling switchover to SPT might cause multicast traffic forwarding failures on the
source-side DR. When disabling switchover to SPT, be sure you fully understand its impact on your
network.
To configure switchover to SPT:
Ste
p
Command Remarks
1. Enter system view.
system-view
N/A
2. Enter IPv6 PIM view.
ipv6 pim [ vpn-instance
vpn-instance-name ]
N/A
3. Configure the criteria for
triggering a switchover to SPT.
spt-switch-threshold { immediacy |
infinity } [ group-policy
acl6-number ]
By default, the device immediately
triggers a switchover to SPT after
receiving the first multicast packet.
Configuring IPv6 BIDIR-PIM
This section describes how to configure IPv6 BIDIR-PIM.
IPv6 BIDIR-PIM configuration task list
Task at a
g
lance
(Required.) Enabling IPv6 BIDIR-PIM