HP 6125XLG - Configuring Ipv6 Multicast Load Splitting; Configuring Ipv6 Multicast Routing and Forwarding; Configuring the RPF Route Selection Rule

256
To enable IPv6 multicast routing:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enable IPv6 multicast routing
and enter IPv6 MRIB view.
ipv6 multicast routing
[ vpn-instance vpn-instance-name ]
By default, IPv6 multicast routing is
disabled.
Configuring IPv6 multicast routing and forwarding
Before you configure IPv6 multicast routing and forwarding, complete the following tasks:
• Configure an IPv6 unicast routing protocol so that all devices in the domain are interoperable at the
network layer.
• Configure IPv6 PIM-DM or IPv6 PIM-SM.
Configuring the RPF route selection rule
You can configure the router to select the RPF route based on the longest prefix match principle. For more
information about RPF route selection, see "RPF check process."
T
o configure an IPv6 multicast routing policy:
Ste
p
Command Remarks
1. Enter system view.
system-view
N/A
2. Enter IPv6 MRIB view.
ipv6 multicast routing
[ vpn-instance vpn-instance-name ]
N/A
3. Configure the device to select
the RPF route based on the
longest prefix match.
longest-match
By default, the route with the
highest priority is selected as the
RPF route.
Configuring IPv6 multicast load splitting
By configuring per-source or per-source-and-group load splitting, you can optimize the traffic delivery
when multiple IPv6 multicast data streams are handled.
You do not need to enable IPv6 multicast routing before this configuration.
To configure IPv6 multicast load splitting:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter IPv6 MRIB view.
ipv6 multicast routing
[ vpn-instance vpn-instance-name ]
N/A
3. Configure IPv6 multicast load
splitting.
load-splitting {source |
source-group }
By default, IPv6 multicast load
splitting is disabled.