HP 6125XLG - Displaying and Maintaining Ipv6 PIM Snooping; Ipv6 PIM Snooping Configuration Example

236
Ste
p
Command Remarks
8. (Optional.) Set the aging
time for the IPv6 PIM
snooping global
downstream ports and
global router ports on the
new master device in IRF
master election.
ipv6 pim-snooping graceful-restart
join-aging-time interval
The default setting is 210.
A global downstream port or a
global router port is a Layer 2
aggregate interface that acts as a
downstream port or router port.
Displaying and maintaining IPv6 PIM snooping
Execute display commands in any view and reset commands in user view.
Task Command
Display information about IPv6 PIM
snooping neighbors.
display ipv6 pim-snooping neighbor [ vlan vlan-id ] [ slot slot-number ]
[ verbose ]
Display IPv6 PIM snooping routing
entries.
display ipv6 pim-snooping routing-table [ vlan vlan-id ] [ slot
slot-number ] [ verbose ]
Display information about IPv6 PIM
snooping router ports.
display ipv6 pim-snooping router-port [ vlan vlan-id ] [ slot
slot-number ]
Display statistics for the IPv6 PIM
messages learned through IPv6 PIM
snooping.
display ipv6 pim-snooping statistics
Clear statistics for the IPv6 PIM
messages learned through IPv6 PIM
snooping.
reset ipv6 pim-snooping statistics
IPv6 PIM snooping configuration example
Network requirements
As shown in Figure 73:
• Source 1 sends multicast data to IPv6 multicast group FF1E::101, and Source 2 sends multicast data
to IPv6 multicast group FF2E::101.
• Receiver 1 belongs to multicast group FF1E::101, and Receiver 2 belongs to multicast group
FF2E::101.
• Router C and Router D run MLD on Ten-GigabitEthernet 1/1/5. Router A, Router B, Router C, and
Router D run IPv6 PIM-SM.
• Ten-GigabitEthernet 1/1/6 on Router A acts as a C-BSR and C-RP.
Configure MLD snooping and IPv6 PIM snooping on Switch A so that Switch A forwards IPv6 multicast
data to only the routers that are interested in the multicast data.