HP 6125XLG - Ipv6 PIM-SM Non-Scoped Zone Configuration Example

314
Protocol: pim-dm, UpTime: 00:02:19, Expires: -
IPv6 PIM-SM non-scoped zone configuration example
Network requirements
As shown in Figure 99:
• VOD streams are sent to receiver hosts in multicast. The receivers of different subnets form stub
networks, and at least one receiver host exist in each stub network. The entire IPv6 PIM-SM domain
contains only one BSR.
• Host A and Host C are multicast receivers in the stub networks N1 and N2.
• Specify VLAN-interface 102 on Switch E as a C-BSR and a C-RP. The C-RP is designated to the IPv6
multicast group range FF0E::101/64. Specify VLAN-interface 101 of Switch D as the static RP on all
the switches to back up the dynamic RP.
• MLDv1 runs between Switch A and N1, and between Switch B, Switch C, and N2.
Figure 99 Network diagram
Table 19 Interface and IPv6 address assignment
Device Interface
IPv6 address
Switch A VLAN-interface 100 1001::1/64
Switch A VLAN-interface 101 1002::1/64
Switch A VLAN-interface 102 1003::1/64
Switch B VLAN-interface 200 2001::1/64
Switch B VLAN-interface 103 2002::1/64
Ethernet
EthernetEthernet
N1N2
Vlan-int101
Vl
an
-int101