EasyManua.ls Logo

HP 6125XLG - Ipv6 PIM-SSM Configuration Example

HP 6125XLG
383 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
328
Flags: 0x0
Uptime: 00:07:21
RPF interface: LoopBack0
List of 2 DF interfaces:
1: Vlan-interface102
2: Vlan-interface103
# Display information about the DF for IPv6 multicast forwarding on Switch D.
[SwitchD] display ipv6 multicast forwarding df-info
Total 1 RP, 1 matched
00001. RP address: 6001::1
Flags: 0x0
Uptime: 00:05:12
RPF interface: Vlan-interface103
List of 2 DF interfaces:
1: Vlan-interface300
2: Vlan-interface400
IPv6 PIM-SSM configuration example
Network requirements
As shown in Figure 102:
• Receivers receive VOD information through multicast. The receiver groups of different organizations
form stub networks, and one or more receiver hosts exist in each stub network. The entire IPv6 PIM
domain operates in the SSM mode.
• Host A and Host C are IPv6 multicast receivers in two stub networks N1 and N2.
• The SSM group range is FF3E::/64.
• MLDv2 runs between Switch A and N1 and between Switch B, Switch C, and N2.

Table of Contents

Other manuals for HP 6125XLG

Related product manuals