HP 6125XLG - Configuration Prerequisites; Configuring a Port-Based Ipv6 Multicast VLAN; Configuring User Port Attributes

244
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Configure a VLAN as an
IPv6 multicast VLAN and
enter its view.
ipv6 multicast-vlan vlan-id
By default, a VLAN is not an IPv6 multicast
VLAN.
3. Assign the specified VLANs
to the IPv6 multicast VLAN as
sub-VLANs.
subvlan vlan-list
By default, an IPv6 multicast VLAN does
not have any sub-VLANs.
Configuring a port-based IPv6 multicast VLAN
Before you assign the users ports that contain the receivers to the IPv6 multicast VLAN, you must first
configure the attributes for the user ports.
You can assign a port to an IPv6 multicast VLAN only when the port is an Ethernet port or a Layer 2
aggregate interface.
Configuration prerequisites
Before you configure a port-based IPv6 multicast VLAN, complete the following tasks:
• Create VLANs as required.
• Enable MLD snooping for the VLAN to be configured as the IPv6 multicast VLAN.
• Enable MLD snooping for all the VLANs that contain the receiver hosts.
Configuring user port attributes
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Configure the link type of the
user port as hybrid.
port link-type hybrid
The default setting is access.
For more information about this
command, see Layer 2—LAN
Switching Command Reference.
4. Specify the PVID of the current
user port as the VLAN to
which the user port belongs.
port hybrid pvid vlan vlan-id
By default, the PVID for a hybrid
port is VLAN 1.
For more information about this
command, see Layer 2—LAN
Switching Command Reference.
5. Configure the current user port
to permit IPv6 multicast VLAN
and to untag the packets.
port hybrid vlan vlan-id-list
untagged
By default, a hybrid port permits
only VLAN 1.
For more information about this
command, see Layer 2—LAN
Switching Command Reference.