HP 6125XLG - Assigning User Ports to an Ipv6 Multicast VLAN; Setting the Maximum Number of Ipv6 Multicast VLAN Forwarding Entries

245
Assigning user ports to an IPv6 multicast VLAN
To configure user ports for an IPv6 multicast VLAN, you must configure a VLAN as an IPv6 multicast
VLAN, and assign the desired user ports to the IPv6 multicast VLAN. You can either assign the user ports
to the IPv6 multicast VLAN in IPv6 multicast VLAN view, or assign the user ports to the IPv6 multicast
VLAN in interface view.
When you configure user ports for an IPv6 multicast VLAN, follow these guidelines:
• The VLAN to be configured as an IPv6 multicast VLAN must exist.
• A port can belong to only one IPv6 multicast VLAN.
Assigning ports to an IPv6 multicast VLAN in IPv6 multicast VLAN view
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Configure an IPv6 VLAN as
an IPv6 multicast VLAN and
enter its view.
ipv6 multicast-vlan vlan-id
By default, a VLAN is not an IPv6
multicast VLAN.
3. Assign ports to the IPv6
multicast VLAN.
port interface-list
By default, an IPv6 multicast VLAN does
not have any user ports.
Assigning a port to an IPv6 multicast VLAN in interface view
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Configure an IPv6 VLAN as
an IPv6 multicast VLAN and
enter its view.
ipv6 multicast-vlan vlan-id
By default, a VLAN is not
an IPv6 multicast VLAN.
3. Return to system view.
quit N/A
4. Enter interface view.
interface interface-type interface-number N/A
5. Assign the current port to the
IPv6 multicast VLAN.
ipv6 port multicast-vlan vlan-id
By default, a user port does
not belong to any IPv6
multicast VLAN.
Setting the maximum number of IPv6 multicast
VLAN forwarding entries
You can set the maximum number of IPv6 multicast VLAN forwarding entries on the device. When the
upper limit is reached, the device does not create IPv6 multicast VLAN forwarding entries until some
entries age out or are manually removed.
If the total number of the entries exceeds the upper limit value that you are setting, the system does not
automatically remove existing entries or create new entries. In this case, HP recommends that you remove
extra entries manually.
To set the maximum number of IPv6 multicast VLAN forwarding entries: