HP 6125XLG - 3 Configure Switch A: # Enable IGMP Snooping Globally; Switcha> System-View; [Switcha] Igmp-Snooping; [Switcha-Igmp-Snooping] Quit

38
[RouterC] interface ten-gigabitethernet 1/1/6
[RouterC-Ten-GigabitEthernet1/1/6] pim sm
[RouterC-Ten-GigabitEthernet1/1/6] quit
6. Configure Router D:
# Enable IP multicast routing.
<RouterD> system-view
[RouterD] multicast routing
[RouterD-mrib] quit
# Enable IGMP on Ten-GigabitEthernet 1/1/5.
[RouterD] interface ten-gigabitethernet 1/1/5
[RouterD-Ten-GigabitEthernet1/1/5] igmp enable
[RouterD-Ten-GigabitEthernet1/1/5] quit
# Enable PIM-SM on Ten-GigabitEthernet 1/1/6.
[RouterD] interface ten-gigabitethernet 1/1/6
[RouterD-Ten-GigabitEthernet1/1/6] pim sm
[RouterD-Ten-GigabitEthernet1/1/6] quit
7. Configure Switch A:
# Enable IGMP snooping globally.
<SwitchA> system-view
[SwitchA] igmp-snooping
[SwitchA-igmp-snooping] quit
# Create VLAN 100, assign Ten-GigabitEthernet 1/1/5 through Ten-GigabitEthernet 1/1/8 to
this VLAN, and enable IGMP snooping and PIM snooping for this VLAN.
[SwitchA] vlan 100
[SwitchA-vlan100] port ten-gigabitethernet 1/1/5 to ten-gigabitethernet 1/1/8
[SwitchA-vlan100] igmp-snooping enable
[SwitchA-vlan100] pim-snooping enable
[SwitchA-vlan100] quit
Verifying the configuration
# On Switch A, display information about PIM snooping neighbors for VLAN 100.
[SwitchA] display pim-snooping neighbor vlan 100
Total 4 neighbors.
VLAN 100: Total 4 neighbors.
10.1.1.1
Slots (0 in total):
Ports (1 in total):
XGE1/1/5 (00:32:43)
10.1.1.2
Slots (0 in total):
Ports (1 in total):
XGE1/1/6 (00:32:43)
10.1.1.3
Slots (0 in total):
Ports (1 in total):
XGE1/1/7 (00:32:43)