258
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter Layer 2 Ethernet
interface/Layer 2 aggregate
interface view.
interface interface-type
interface-number
N/A
3. Configure a static multicast
MAC address entry.
mac-address multicast
mac-address vlan vlan-id
By default, no static multicast MAC
address entries exist.
Configuring IPv6 multicast forwarding between sub-VLANs of a
super VLAN
A super VLAN is associated with multiple sub-VLANs. Sub-VLANs are isolated with each other at Layer
2. For information about the super VLAN and sub-VLANs, see Layer 2—LAN Switching Configuration
Guide.
To configure multicast forwarding between sub-VLANs of a super VLAN:
Ste
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter VLAN interface view.
interface vlan-interface
interface-number
N/A
3. Configure IPv6 multicast
forwarding between
sub-VLANs of a super VLAN.
ipv6 multicast forwarding
supervlan community
By default, IPv6 multicast data
cannot be forwarded between
sub-VLANs of a super VLAN.
4. Clear all IPv6 multicast
forwarding entries with super
VLAN interface as the
incoming interface.
reset ipv6 multicast [ vpn-instance
vpn-instance-name ]
forwarding-table
{ { ipv6-source-address
[ prefix-length ] |
ipv6-group-address [ prefix-length ]
| incoming-interface
{ interface-type interface-number } }
* | all }
N/A
Displaying and maintaining IPv6 multicast routing
and forwarding
CAUTION:
The reset commands might cause IPv6 multicast data transmission failures.
Execute display commands in any view and reset commands in user view.
To Next Page
Loading...
