HP 6125XLG - SA Message Filtering Configuration

162
Protocol: pim-sm, UpTime: - , Expires: -
The output shows that Switch D now acts as the RP for Source 2 and Host B.
SA message filtering configuration
Network requirements
As shown in Figure 55, OSPF runs within and among the PIM-SM domains to provide unicast routing.
Set up an MSDP peering relationship between Switch A and Switch C and between Switch C and Switch
D.
Source 1 sends multicast data to multicast groups 225.1.1.0/30 and 226.1.1.0/30, and Source 2 sends
multicast data to the multicast group 227.1.1.0/30.
Configure SA message filtering rules so that:
• Host A and Host B receive the multicast data only addressed to multicast groups 225.1.1.0/30 and
226 .1.1. 0 / 3 0 .
• Host C receives the multicast data only addressed to multicast groups 226.1.1.0/30 and
227.1.1. 0 / 30 .
Figure 55 Network diagram
Table 13 Interface and IP address assignment
Device Interface IP address
Source 1 — 10.110.3.100/24
Source 2 — 10.110.6.100/24
Switch A VLAN-interface 100 10.110.1.1/24
Switch A VLAN-interface 102 10.110.2.1/24
Switch A VLAN-interface 101 192.168.1.1/24
Switch A Loopback 0 1.1.1.1/32
MSDP peers
PIM-SM 1 PIM-SM 2 PIM-SM 3
Loop0
Loop0
Source 1
Source 2
Receiver
Host B
Receiver
Host C
Receiver
Host A
Vlan-int100
Vlan-int200
Switch A
Switch C
Switch D
Switch B
V
l
a
n
-
i
n
t
1
0
3
V
l
a
n
-
i
n
t
1
0
3
V
l
a
n
-
i
n
t
1
0
1
V
l
a
n
-
i
n
t
1
0
1
Vlan-int300
Vlan-int104
Vlan-int104
Vlan-int500
Vlan-int400