310
Task Command
Display BSR information in the IPv6
PIM-SM domain.
display ipv6 pim [ vpn-instance vpn-instance-name ] bsr-info
Display information about the
routes used by IPv6 PIM.
display ipv6 pim [ vpn-instance vpn-instance-name ] claimed-route
[ ipv6-source-address ]
Display C-RP information in the IPv6
PIM-SM domain.
display ipv6 pim [ vpn-instance vpn-instance-name ] c-rp [ local ]
Display DF information in the IPv6
BIDIR-PIM domain.
display ipv6 pim [ vpn-instance vpn-instance-name ] df-info
[ ipv6-rp-address ]
Display IPv6 PIM information on an
interface.
display ipv6 pim [ vpn-instance vpn-instance-name ] interface
[ interface-type interface-number ] [ verbose ]
Display IPv6 PIM neighbor
information.
display ipv6 pim [ vpn-instance vpn-instance-name ] neighbor
[ ipv6-neighbor-address | interface interface-type interface-number |
verbose ] *
Display IPv6 PIM routing table
information.
display ipv6 pim [ vpn-instance vpn-instance-name ] routing-table
[ ipv6-group-address [ prefix-length ] | ipv6-source-address
[ prefix-length ] | flags flag-value | fsm | incoming-interface
interface-type interface-number | mode mode-type | outgoing-interface
{ exclude | include | match } interface-type interface-number ] *
Display RP information in the IPv6
PIM-SM domain.
display ipv6 pim [ vpn-instance vpn-instance-name ] rp-info
[ ipv6-group-address ]
Display statistics for IPv6 PIM
packets.
display ipv6 pim statistics
IPv6 PIM configuration examples
IPv6 PIM-DM configuration example
Network requirements
As shown in Figure 98:
• VOD streams are sent to receiver hosts in multicast. The receiver groups of different organizations
form stub networks, and one or more receiver hosts exist in each stub network. The entire IPv6 PIM
domain is operating in the dense mode.
• Host A and Host C are multicast receivers in two stub networks N1 and N2.
• MLDv1 runs between Switch A and N1 and between Switch B, Switch C, and N2.
To Next Page
Loading...
