HP 6125XLG - Configuration Prerequisites; Configuring a Port-Based Multicast VLAN; Configuring User Port Attributes

44
Ste
p
Command Remarks
2. Configure a VLAN as a
multicast VLAN and enter
its view.
multicast-vlan vlan-id By default, a VLAN is not a multicast VLAN.
3. Assign the specified
VLANs to the multicast
VLAN as sub-VLANs.
subvlan vlan-list
By default, a multicast VLAN does not have
any sub-VLANs.
Configuring a port-based multicast VLAN
To configure a port-based multicast VLAN, you must configure the attributes for user ports that contain
receiver hosts, and then assign the user ports to the multicast VLAN.
You can assign a port to a multicast VLAN only when the port is an Ethernet port or a Layer 2 aggregate
interface.
Configuration prerequisites
Before you configure a port-based multicast VLAN, complete the following tasks:
• Create VLANs as required.
• Enable IGMP snooping for the VLAN to be configured as the multicast VLAN.
• Enable IGMP snooping for all the VLANs that contain the receiver hosts.
Configuring user port attributes
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type interface-number N/A
3. Configure the link
type of the user port
as hybrid.
port link-type hybrid
The default setting is access.
For more information about this
command, see Layer 2—LAN
Switching Command Reference.
4. Specify the PVID of
the current user port
as the VLAN to which
the user port belongs.
port hybrid pvid vlan vlan-id
By default, the PVID for a hybrid
port is VLAN 1.
For more information about this
command, see Layer 2—LAN
Switching Command Reference.
5. Configure the current
user port to permit
multicast VLAN and
to untag the packets.
port hybrid vlan vlan-id-list untagged
By default, a hybrid port permits
only VLAN 1.
For more information about this
command, see Layer 2—LAN
Switching Command Reference.