HP 6125XLG - Configuration Procedure; MLD Configuration Examples; Network Requirements

270
MLD configuration examples
Network requirements
As shown in Figure 84:
• VOD streams are sent to receiver hosts in multicast. Receiver hosts of different organizations form
stub networks N1 and N2. Host A and Host C are multicast receiver hosts in N1 and N2,
respectively.
• MLDv1 runs between Switch A and N1, and between the other two switches (Switch B and Switch
C) and N2. Switch A acts as the MLD querier in N1.
• Switch B acts as the MLD querier in N2 because it has a lower IPv6 address.
Configure an IPv6 multicast group filter on Switch A to achieve the following goals:
• The hosts in N1 can join only the IPv6 multicast group FF1E::101.
• The hosts in N2 can join any IPv6 multicast groups.
Figure 84 Network diagram
Configuration procedure
1. Assign an IPv6 address and prefix length to each interface as shown in Figure 84. (Details not
shown.)
2. Configure OSPFv3 on the switches to meet the following requirements: (Details not shown.)
{ The switches are interoperable at the network layer.
{ The switches can dynamically update their routing information.
3. Enable the IPv6 multicast routing, MLD, and IPv6 PIM-DM:
# On Switch A, enable IPv6 multicast routing.
Switch A
Switch B
Switch C
Querier
N1
N2
Receiver
Receiver
Host A
Host B
Host C
Host D
Vlan-int100
3000::12/64
Vlan-int200
3001::10/64
Vlan-int200
3001::12/64
V
l
a
n
-
i
n
t
1
0
1
V
l
a
n
-
i
n
t
2
0
1
V
l
a
n
-
i
n
t
2
0
2
IPv6 PIM network