237
Figure 73 Network diagram
Configuration procedure
1. Assign an IPv6 address and prefix length for each interface according to Figure 73. (Details not
shown.)
2. Configure OSPFv3 on the routers to meet the following requirements: (Details not shown.)
{ The switches are interoperable at the network layer.
{ The switches can dynamically update their routing information.
3. Configure Router A:
# Enable IPv6 multicast routing.
<RouterA> system-view
[RouterA] ipv6 multicast routing
[RouterA-mrib6] quit
# Enable IPv6 PIM-SM on each interface.
[RouterA] interface ten-gigabitethernet 1/1/5
[RouterA-Ten-GigabitEthernet1/1/5] ipv6 pim sm
[RouterA-Ten-GigabitEthernet1/1/5] quit
[RouterA] interface ten-gigabitethernet 1/1/6
[RouterA-Ten-GigabitEthernet1/1/6] ipv6 pim sm
[RouterA-Ten-GigabitEthernet1/1/6] quit
# Configure Ten-GigabitEthernet 1/1/6 as a C-BSR and a C-RP.
[RouterA] ipv6 pim
[RouterA-pim6] c-bsr 1001::1
[RouterA-pim6] c-rp 1001::1
[RouterA-pim6] quit
4. Configure Router B:
# Enable IPv6 multicast routing.
<RouterB> system-view
[RouterB] ipv6 multicast routing
[RouterB-mrib6] quit
# Enable IPv6 PIM-SM on each interface.
To Next Page
Loading...
