238
[RouterB] interface ten-gigabitethernet 1/1/5
[RouterB-Ten-GigabitEthernet1/1/5] ipv6 pim sm
[RouterB-Ten-GigabitEthernet1/1/5] quit
[RouterB] interface ten-gigabitethernet 1/1/6
[RouterB-Ten-GigabitEthernet1/1/6] ipv6 pim sm
[RouterB-Ten-GigabitEthernet1/1/6] quit
5. Configure Router C:
# Enable IPv6 multicast routing.
<RouterC> system-view
[RouterC] ipv6 multicast routing
[RouterC-mrib6] quit
# Enable MLD on Ten-GigabitEthernet 1/1/5.
[RouterC] interface ten-gigabitethernet 1/1/5
[RouterC-Ten-GigabitEthernet1/1/5] mld enable
[RouterC-Ten-GigabitEthernet1/1/5] quit
# Enable IPv6 PIM-SM on Ten-GigabitEthernet 1/1/6.
[RouterC] interface ten-gigabitethernet 1/1/6
[RouterC-Ten-GigabitEthernet1/1/6] ipv6 pim sm
[RouterC-Ten-GigabitEthernet1/1/6] quit
6. Configure Router D:
# Enable IPv6 multicast routing.
<RouterD> system-view
[RouterD] ipv6 multicast routing
[RouterD-mrib6] quit
# Enable MLD on Ten-GigabitEthernet 1/1/5.
[RouterD] interface ten-gigabitethernet 1/1/5
[RouterD-Ten-GigabitEthernet1/1/5] mld enable
[RouterD-Ten-GigabitEthernet1/1/5] quit
# Enable IPv6 PIM-SM on Ten-GigabitEthernet 1/1/6.
[RouterD] interface ten-gigabitethernet 1/1/6
[RouterD-Ten-GigabitEthernet1/1/6] ipv6 pim sm
[RouterD-Ten-GigabitEthernet1/1/6] quit
7. Configure Switch A:
# Enable MLD snooping globally.
<SwitchA> system-view
[SwitchA] mld-snooping
[SwitchA-mld-snooping] quit
# Create VLAN 100, assign Ten-GigabitEthernet 1/1/5 through Ten-GigabitEthernet 1/1/8 to
this VLAN, and enable MLD snooping and IPv6 PIM snooping for the VLAN.
[SwitchA] vlan 100
[SwitchA-vlan100] port ten-gigabitethernet 1/1/5 to ten-gigabitethernet 1/1/8
[SwitchA-vlan100] mld-snooping enable
[SwitchA-vlan100] ipv6 pim-snooping enable
[SwitchA-vlan100] quit
To Next Page
Loading...
