139
Solution
1. Use display ip routing-table to verify that unicast routes to the C-RPs and the BSR are available on
each router and that a route is available between each C-RP and the BSR. Make sure each C-RP
has a unicast route to the BSR, the BSR has a unicast route to each C-RP, and each router on the
network has unicast routes to the C-RPs.
2. Use display pim bsr-info to verify that the BSR information exists on each router, and then use
display pim rp-info to verify that the RP information is correct on each router.
3. Use display pim neighbor to verify that PIM neighboring relationship has been correctly
established among the routers.
To Next Page
Loading...
