167
• When an MSDP peer receives an SA message, it performs an RPF check on the message. If the
MSDP peer finds that the remote RP address is the local RP address, it discards the SA message.
Solution
1. Use the display ip routing-table command to verify that the unicast route between the routers is
reachable.
2. Verify that a unicast route is available between the two routers that will establish an MSDP peering
relationship.
3. Verify the configuration of the originating-rp command. In the Anycast RP application environment,
use the originating-rp command to configure the RP address in the SA messages, which must be
the local interface address.
4. Verify that the C-BSR address is different from the Anycast RP address.
To Next Page
Loading...
