233
Solution
1. Use the display acl ipv6 command to verify that the configured IPv6 ACL meets the IPv6 multicast
group filter requirements.
2. Use the display this command in MLD-snooping view or in a corresponding interface view to verify
that the correct IPv6 multicast group filter has been applied. If not, use the group-policy or
mld-snooping group-policy command to apply the correct IPv6 multicast group filter.
3. Use the display mld-snooping command to verify that the function of dropping unknown IPv6
multicast data is enabled. If not, use the mld-snooping drop-unknown command to enable
dropping unknown IPv6 multicast data.
To Next Page
Loading...
