EasyManua.ls Logo

HP 6125XLG - Page 271

HP 6125XLG
383 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
261
# On Switch C, create service loopback group 1, and specify its service type as Tunnel.
<SwitchC> system-view
[SwitchC] service-loopback group 1 type tunnel
# Add Ten-GigabitEthernet 1/1/7 to service loopback group 1. Ten-GigabitEthernet 1/1/7 does
not belong to VLAN 200 or VLAN 102.
[SwitchC] interface ten-gigabitethernet 1/1/7
[SwitchC-Ten-GigabitEthernet1/1/7] port service-loopback group 1
[SwitchC-Ten-GigabitEthernet1/1/7] quit
# Create interface Tunnel 0 and specify the tunnel encapsulation mode as GRE over IPv6.
[SwitchC] interface tunnel 0 mode gre ipv6
# Assign an IPv6 address to interface Tunnel 0, and specify its source and destination addresses.
[SwitchC-Tunnel0] ipv6 address 5001::2 64
[SwitchC-Tunnel0] source 3001::2
[SwitchC-Tunnel0] destination 2001::1
[SwitchC-Tunnel0] quit
4. Enable IPv6 multicast routing, IPv6 PIM-DM, and MLD:
# On Switch A, enable IPv6 multicast routing, and enable IPv6 PIM-DM on each interface.
[SwitchA] ipv6 multicast routing
[SwitchA-mrib6] quit
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] ipv6 pim dm
[SwitchA-Vlan-interface100] quit
[SwitchA] interface vlan-interface 101
[SwitchA-Vlan-interface101] ipv6 pim dm
[SwitchA-Vlan-interface101] quit
[SwitchA] interface tunnel 0
[SwitchA-Tunnel0] ipv6 pim dm
[SwitchA-Tunnel0] quit
# On Switch C, enable IPv6 multicast routing.
[SwitchC] ipv6 multicast routing
[SwitchC-mrib6] quit
# Enable MLD on VLAN-interface 200 (the interface that connects to the receiver host).
[SwitchC] interface vlan-interface 200
[SwitchC-Vlan-interface200] mld enable
[SwitchC-Vlan-interface200] quit
# Enable IPv6 PIM-DM on the other interfaces.
[SwitchC] interface vlan-interface 102
[SwitchC-Vlan-interface102] ipv6 pim dm
[SwitchC-Vlan-interface102] quit
[SwitchC] interface tunnel 0
[SwitchC-Tunnel0] ipv6 pim dm
[SwitchC-Tunnel0] quit
Verifying the configuration
# Send an MLD report from the Receiver to join the IPv6 multicast group FF1E::101. (Details not shown.)
# Send IPv6 multicast data from Source to the IPv6 multicast group FF1E::101. (Details not shown.)

Table of Contents

Other manuals for HP 6125XLG

Related product manuals