HP
890411
Option
001
Enhancements
3c-3
f3
Burst
Length
-
The burst length specifies the number of times the
Gquence
will
be repeated
if
the burst mode
is
used. The
minimum
number
is
one (similar to the Single mode of the other sequence
modes); the maximum number
is
127.
WFORM
-
This
function allows you to select any one of the
six
standard waveforms to be output. Since this setting defines the
waveform for all Hop
RAM
addresses, the waveform type can not be
hopped.
Sequence Editing
f7
Seq
index
-
The sequence index indicates where a sequence entry
Zrelative to the entire sequence. You can use
this
function to jump to
any place in the sequence for editing
purposes.
In the menu above, the sequence index
is
1.
This
indicates that the
number
0
is
the first number in the sequence.
If
the number 15 was
entered for the sequence index, the displayed sequence would change
so
that the 15th character
in
the sequence
(E
hex) would be at the far
left of the displayed sequence.
f2
Seq
End
-
Zldresses
in
the sequence.
The sequence end defines the number
,of
Hop
RAM
f4
Edit Sequence
-
Pressing
f4
enables functions that allow you to
msert or delete sequence entries.
-
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
