HP CodeMaster XL+ M1722A - Defibrillator Troubleshooting

Troubleshooting
Troubleshooting
7-2
Troubleshooting the Defibrillator
Table 7-2 Defibrillator Messages
Message Cause Possible Solutions
NO PADDLES
Paddle set is not connected to the
defibrillator.
Attach external paddles,
internal paddles, or pads
adaptor as required.
LEADS OFF
Leads are not securely attached to
the patient or the cable is not con-
nected to the defibrillator.
Attach lead.
USE LEADS
Paddles are connected to the
defibrillator and:
•
• was pressed when
PADDLES is selected.
• Press to remove
the defibrillator from sync
mode.
• Defibrillator is in sync mode
and
PADDLES is selected.
• Select
PADS or LEAD
I, II, or
III
instead of
PADDLES.
• Defibrillator is in defib mode
and
PADDLES is selected
when leads are attached to the
patient.
• Select
PADS or LEAD
I, II
, or III instead
of
PADDLES.
• Defibrillator is in defib mode,
PADDLES is the ECG source
when attaching leads to the
patient.
• Select
PADS or LEAD
I, II
, or III instead
of
PADDLES.
50J MAXI-
MUM
Internal paddles are attached and
the Energy Select control has been
turned past 50 joules.
CodeMaster XL+ will charge
to 50 joules.
LOW BAT-
TERY
CodeMaster XL+ is not connected
to AC power and the battery voltage
is below the low battery threshold.
Connect the unit to AC
power.
SETUP LOST
Call for service.
Sync
Sync