HP Digital Sender Flow 8500 fn2 - Energy-Conservation Settings

Energy-conservation settings
Introduction
●
Set the sleep timer and congure the scanner to use 2 watts or less of power
●
Set the sleep schedule
Congure sleep settings to reduce power usage when the product is idle.
Set the sleep timer and congure the scanner to use 2 watts or less of power
The sleep settings aect how much power the product uses, the wake/sleep time, how quickly the product
enters sleep mode, and how quickly the product wakes up from sleep mode.
To congure the product to use 2 watt or less of power while in sleep mode, enter times for both the Sleep after
Inactivity and Auto O after sleep settings.
1. From the Home screen on the product control panel, select Settings.
2. Open the following menus:
●
General
●
Energy Settings
●
Sleep Settings
3. Select Sleep after Inactivity to specify the number of minutes the product is inactive before it enters sleep
mode. Enter the appropriate time period.
4. Select Auto O after sleep to put the product into a deeper power save mode after a period of sleep. Enter
the appropriate time period.
NOTE: By default, the product will wake from Auto O in response to any activity other than USB or Wi-Fi.
For greater energy settings, you can set it to wake only to the power button by selecting Shut down (wake
on power button only).
5. Select Done to save the settings.
Set the sleep schedule
Use the Sleep Schedule feature to congure the product to automatically wake or go into Sleep mode at specic
times on specic days of the week.
1. From the Home screen on the product control panel, select Settings.
2. Open the following menus:
●
General
●
Energy Settings
●
Sleep Schedule
ENWW Energy-conservation settings 105