HP Digital Sender Flow 8500 fn2 - Set up Scan to Email; Introduction; Before you begin

Set up Scan to Email
●
Introduction
●
Before you begin
●
Step one: Access the HP Embedded Web Server (EWS)
●
Step two: Congure the Network Identication settings
●
Step three: Congure the Send to Email feature
●
Step four: Congure the Quick Sets (optional)
●
Step ve: Set up Send to Email to use Oice 365 Outlook (optional)
Introduction
The product has a feature that enables it to scan a document and send it to one or more email addresses. To use
this scan feature, the product must be connected to a network; however, the feature is not available until it has
been congured. There are two methods for conguring Scan to Email, the Scan to Email Setup Wizard for basic
and Email Setup for advanced. Use the following information to set up the Scan to Email feature.
Before you begin
To set up the Scan to Email feature, the product must have an active network connection.
Administrators need the following information before beginning the conguration process.
●
Administrative access to the product
●
DNS suix (e.g., companyname.com)
●
SMTP server (e.g., smtp.mycompany.com)
NOTE: If you do not know the SMTP server name, SMTP port number, or authentication information,
contact the email/Internet service provider or system administrator for the information. SMTP server
names and port names are typically found by doing an Internet search. For example, use terms like "Gmail
smtp server name" or "Yahoo smtp server name" to search.
●
SMTP server authentication requirements for outgoing email messages, including the user name and
password used for authentication, if applicable.
NOTE: Consult your email service provider's documentation for information on digital sending limits for your
email account. Some providers may temporarily lock your account if you exceed your sending limit.
ENWW Set up the scanner 19