HP Digital Sender Flow 8500 fn2 - The product is using incorrect link and duplex settings for the network; New software programs might be causing compatibility problems; The computer or workstation might be set up incorrectly; The product is disabled, or other network settings are incorrect

●
For Windows, click Start, click Run, type cmd, and then press Enter.
b. Type ping followed by the IP address for your product.
c. If the window displays round-trip times, the network is working.
2. If the ping command failed, verify that the network hubs are on, and then verify that the network settings,
the product, and the computer are all congured for the same network (also known as subnet).
The product is using incorrect link and duplex settings for the network
HP recommends leaving these settings in automatic mode (the default setting). If you change these settings, you
must also change them for your network.
New software programs might be causing compatibility problems
Verify that any new software programs are correctly installed and that they use the correct scan driver.
The computer or workstation might be set up incorrectly
1. Check the network drivers, scan drivers, and the network redirection settings.
2. Verify that the operating system is congured correctly.
The product is disabled, or other network settings are incorrect
1. Review the product’s conguration/networking pages to check the status of the network settings and
protocols.
2. Recongure the network settings if necessary.
128 Chapter 5 Solve problems ENWW